Our claim is: If you do not achieve the same results in terms of results in Acne scar attenuation you would get in cosmetic clinics through laser treatments we will refund you in full.
If you are looking to compare the results you get at cosmetic clinics with laser treatment you will be pleasantly surprised at the fact that you will be able to achieve if not the same very similar results to expensive laser treatments without the risks and costs of laser treatments this is our promise.
The use of chemical peels is one of the most effective ways to attenuate and eventually remove acne scars.
Number of applications required to achieve the desired results for acne scar attenuation and eventual removal.
Please note that cosmetic chemical peels are one of the most effective ways to attenuate and even eventually removing acne scars. This is done through the well known process of exfoliation. High Grade glycolic acid peels allow you to achieve the same results which you would achieve in a cosmetic clinic using laser treatments. However you have to use for product habitually in order to have appreciable acne scar attenuation results.
How doe 70% Glycolic acid gel peel compares to laser treatment sin cosmetic clinics
Only use this product after you have read and understood the patch test instructions below.
Please note that incorrect use or incorrect aftercare use can lead to:
Unnecessary swelling (temporary), discomfort and pain Scarring, Hypo and /or hyperpigemntation, Infection and/or delayed healing if the inappropriate aftercare is used, Unexpected downtime, distress due to unexpected downtime.
Mandatory Patch Tests.
The patch test is required and mandatory for you to to learn the effects of the XanthRemover on your skinbefore you use it.
Apply a tiny amount of gel below the chin area and on the forearm, the area to be covered should not exceed 0.5 cm square (small area). Keep the gel for 3 minutes at most. Wipe off using a clean makeup cotton pad and rinse with water. If the treated part presents redness and itching for longer than 24 hours, avoid the use of the product.
Apply a tiny amount of gel somewhere else below the chin area and forearm, the area to be covered should not exceed 0.5 cm square (small area). Keep the gel for 10 minutes at most. Wipe off and rinse with water.
Apply a tiny amount of gel somewhere else below the chin area and forearm, the area to be covered should not exceed 0.5 cm square (small area). Keep the gel for 15 minutes at most. Wipe off and rinse with water.
This patch tests will serve to make sure you do not have any adverse reaction to the gel. Also, you will learn how to use the product by observing the peeling effects after a short duration of the application.
Apply a tiny amount of gel on a small area you want to treat. Keep the gel for 10 minutes. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes.
Apply a tiny amount of gel on a different small area as the previous day you want to treat. Keep the gel for 20 minutes. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes. Observe the peeling effects over the next few days.
If the peeling effects are not satisfactory apply a tiny amount of gel on a different small area as before, on an area of the face face you want to treat. Keep the gel for longer for example 40 minutes. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes. Observe the peeling effects over the next few days.
If you notice any undesired effect stop using the product.
You should have learned that the longer you keep the gel on, stronger and deeper the peeling effects of the product. Apply the gel on a fourth untreated area for even longer than before if you deem it appropriate based on the previous peeling results and you can choose the duration of the application. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes.
The above patch tests will serve for you to get used to the way the Gel works on your skin. You should have learned that the longer you keep the gel on the more the peeling effects of the product on your Brown Spots. In the unlikely event of an adverse reaction of the gel stop using it.
Modality of Application
- Wash your hands.
- Cleanse and dry thoroughly the area where the product will be applied. Use the degreasing protocol if required.
- Apply on the acne scars as well as the surrounding area as you would in the normal skin chemical peel protocol.
- Keep the gel on for as long as you deem necessary to achieve the desired skin peel effects which will eventually lead to the attenuation of your acne scars. There is no maximum length of application this is decided by you, based on your skin reaction to the High Grade Glycolic acid Gel.
Once you are satisfied with the degree of ablation, wipe off the Glycolic Acid Gel using a clean make-up cotton pad and rinse with warm water.
One of two days later you should see the peeling /scabbing effect start to take place. This is normal. Let the area recover on its own. The longer the length of application of the hugh grade glycolic acid gel the less treatments you will require to achieve the desired ance scar attenuation results. Conversely the less you keep the gel on the more applications you will require.
In most cases, the acne scars are attenuated visibly in 10 sessions.The longer you keep the Product on during each application the more the peeling effects. As a consequence the longer you keep your formulation on the less applications are needed to achieve satisfactory results. Some of our customers have been able to achieve the desired results in 5 to 6 sessions just by keeping the gel on for over 1 hour per application.
Allow a minimum of 2 weeks intervals between applications . In the unlikely event, the scabbing/peeling process is still on going after the 2 weeks’ interval wait until the area has returned to normal to reapply. DO NOT USE makeup ON THE AREA YOU HAVE USED THE PRODUCT UNTIL THE PEELING EFFECT IS OVER.
Also before applying the XanthRemover bear in mind that the scabbing/peeling process may not look pretty for 7 to 10 days soon after the application, therefore it is better to plan ahead and ensure you do not have important upcoming events. Do not apply any makeup during the peeling process.
Do not engage in dangerous or strenuous activities and do NOT WEAR ANY TYPE OF MAKE-UP during the peeling or scabbing process as this could jeopardize the peeling process, increase the chances of infections and therefore increase the risk of unnecessary complications including permanent scarring.
Apply total sun protection/sunscreen after the peeling has taken place up until three months you stopped applying the gel and you achieved the desired results. You must avoid any direct sun exposure for at least three months after the application of the gel. Failure to do so can lead to hyper- pigmentation as well as hypo-pigmentation.
Scars tissues may result due to the misuse in high grade cosmetic peels.
What to do in case the peeling effects are not strong enough in my case?
The XanthRemover has high concentration of Glycolic Acid and hence it is very strong per se. However in some circumstances the user would like to get very strong burning or peeling effects especially when using the product for acne scar attenuation.
1) The first course of action is increase the length of application. The longer the Product is kept on the skin, the deeper the burning or peeling effects.
2) If just keeping the Xanthremover gel on for longer does not cut it, then you can increase the effects of the XanthRemover by de-greasing the skin before applying the XanthRemover. The natural way of doing it is applying vinegar on the skin before the use of the XanthRemover. First you have to wash the skin thoroughly, then you dry it, and last using a cotton pad dipped into vinegar rub the skin a number of times with the cotton pad and vinegar. Dry the skin and apply the XanthRemover immediately after. This will enhance the effects of the XanthRemover.
3) If the use of vinegar is not enough for you the next step is Deep de-greasing using acetone. Wash the part of the skin you want to apply the XanthRemover on and once you dry it apply acetone rubbing it using a cotton cloth. Rub the area of the skin a number of times and then apply the XanthRemover once the skin is dry from the Acetone. Please be careful because the effects the XanthRemover will be very different from before. The burns and peeling effects will be much deeper.